Solide comme l'acier, léger comme l'air, une couleur qui dure™
Un polymère révolutionnaire offrant une résistance, une précision et une durabilité inégalées, tout en étant près de sept fois plus léger que l'acier. Impossible ? Découvrez TitanCore™ , le matériau de pointe qui équipe les systèmes de rétention de neige avancés d'Arctic Anchor.
The World’s First Fully Clear Snow Rail System
Our Story in Numbers
10+
Years
Clear rail backed by a 10+ year anti yellowing warranty for long term appearance.
HPT-UVA
UV Additives
Resists the yellowing and clouding that shorten the life of typical clear guards.
100%
Color Matching
No stress on making sure the system matches the paint, clear covers all colors.
Lifetime Waterproofing Built In
Installers can live with many things, but not leaks.
The ArcticAnchor™ Exposed Fastener system is designed so each stand seals as it is fastened to the roof surface, helping protect against water entry at every point.
Pre-applied butyl seal
Each stand comes with a 2.5 mm butyl strip bonded to the base. Under fastening load, it compresses to seal the entire contact area against water entry.
Neoprene washered fasteners
Five #10 self-tapping fasteners per stand clamp the butyl and seal every penetration in one step.
Built-In Ice Stoppers
When installed to our instructions, waterproofing is covered for the life of the system.
Install in Three Quick Steps
Install the Exposed Fastener Rail System in three straightforward steps once your layout is set.
Snap a straight, level line according to your layout. Position each stand with the preinstalled butyl strip down on a clean, dry panel flat or rib.
Fasten the stand using the included fasteners. Tighten until the neoprene washers show even compression all the way around. Do not over tighten.
Feed the rail through the stands along the layout line. Install rail joiners at any rail breaks and end caps at terminations, then final check for alignment.
1000 lbs of Force
At this stage, the 18" rail section shows its first flex under heavy load—yet remains fully stable and secure.
2000 lbs of Force
Even at double the force, the rail demonstrates resilience, holding shape without cracks or failures.
3000 lbs of Force
Under extreme pressure, the rail bends further but returns to its original form with zero permanent deformation.
Le produit de l'innovation
Choose Your Exposed Fastener Stand
Both Exposed Fastener stands use the same rail system. Use this guide to choose the right stand based on rib height, panel profile, and snow load conditions.
Bientôt disponible à l'achat en ligne !
Pourquoi choisir Arctic Anchor pour votre rétention de neige
Color-Match Any Roof
Customize your ArcticAnchor™ system to blend with any roof color, UV-stabilized, no costly add-ons.
Instant Savings For Everyone
Get a tailored quote in minutes using our project calculator, with bulk discounts starting at $8/ft.
Fast, Job-Site Delivery
Flexible shipping ensures your ArcticAnchor™ products arrive on time, directly to your job site or warehouse.
Consult with Experts
Our specialists are ready online to guide your project with expertise. Reach out via chat/email at any time.
Spécifications de la série Rail
Composants
Rails
4ft (Retail)
7ft (Wholesale)
HPT-UVA Stabilized
Patented Triangular Profile
Stands
1 Rail (0"-1.25" Clearence)
2 Hole (0"-2" Clearence)
Fasteners
#10 x 1-½" Self-Drilling Screws with Neoprene Bonded Sealing Washers, Hex Washer Head
Color Matched to Stand & Rail
Accessories
Joiners (Friction fit)
End Caps (Friction fit)
Performance
Rails
Rated for 3000 lbs per Linear Foot
Stands
Vertical Pull Test: 3000lbs
Horizontal Shear Test: 3500lbs
Thermal Stability
Operating Range -40°C (-40°F) to +70°C (+158°F)
Minimal Thermal Expansion & Contraction
Corrosion Resistance
100% Rust-Proof Polymer, No Coatings Required
UV Stability & Color Retention
Fully HPT-UVA Stabilized, Fade Resistant Colors Integrated Throughout Polymer
Tests et garantie
Tests Performed and Passed
ASTM E8/E8M
ASTM D5961
ASTM D6264
ASTM D2990
ISO 4892-2:2013/Amd.1:2021
IEC 60068-2-1:2007
IEC 60068-2-2:2007
ASTM D1183
ASTM D794
GB/T 2423.4-93 (IEC 68-2-30)
Warranty
Limited Lifetime Warranty
-
Manufacturer’s Defect Coverage:
Covers manufacturing defects, corrosion, and premature product failure. -
Structural Integrity Guarantee:
Ensures products maintain structural performance, load capacity, and damage-free attachment. -
Color-Fade Protection:
UV-stabilized colors guaranteed not to materially fade beyond industry standards. -
Extreme Temperature Rated:
Engineered and tested to perform reliably down to -40°C (-40°F). -
Warranty Period:
Lifetime of original building owner or until supporting structure is no longer commercially serviceable (whichever occurs first). -
Support:
Dedicated product specialists available for installation support and warranty inquiries.
See More Details
Product visuals are for illustrative purposes only. Final color, finish, and configuration may vary based on order specifications and roof conditions.
All pricing shown is based on standard residential applications and is subject to change without notice. Large-scale and commercial pricing may vary depending on volume, location, and delivery terms.
Load capacities and performance specifications are based on controlled testing and outputs from the ArcticAnchor™ Load Calculator. Actual performance may vary based on roof structure, installation quality, and environmental conditions. Always apply a minimum safety factor of 2 when designing your system.
Warranty coverage is subject to the terms outlined in the ArcticAnchor™ Limited Lifetime Warranty. Pre-installed screws must be torqued according to the provided specifications to remain eligible for coverage.
ArcticAnchor™ reserves the right to modify product designs, specifications, or materials at any time without prior notice.
For full details, consult our warranty page and installation guide.